Epson 1200S - Manual (Page 102)

95
CE marking
230 V model
Low Voltage Directive 73/23/EEC EN
60950
EMC Directive 89/336/EEC EN 55022
Class B
EN 61000-3-2
EN 61000-3-3
EN 50082-1
IEC 801-2
IEC 801-3
IEC 801-4
SCSI Interface
Interface type
ANSI X3T9.2/375R Revision 10L
(SCSI-2)
Functions
BUS FREE phase
ARBITRATION phase
SELECTION/
RESELECTION phase
COMMAND phase
(the Logical Unit Number is fixed to 0
and the command link function is not
supported)
DATA phase
Data in phase
Data out phase
STATUS phase
MESSAGE phase
MESSAGE IN phase
MESSAGE OUT phase
ATTENTION condition
RESET condition
Logic level
TTL compatible
Electrical standard
ANSI X3T9.2/375R Revision 10L
(SCSI-2)
ID Setting
Selectable from 0 to 7 (factory setting: 2)
Terminator
Internal terminator selectable
(enable/disable)
Connector type
Two half pitch 50-pin connectors
Connector pin arrangement
Initialization methods
The scanner can be initialized (returned
to a fixed set of conditions) in the
following ways:
Transparency Unit
Specifications
Basic Specifications
Dimensions
Width: 8.7 inches (222 mm)
Depth: 12.0 inches (305 mm)
Height: 1.4 inches (36 mm)
Weight
1.5 lb (0.7 kg)
Hardware
initialization
*The scanner is turned on.
*The scanner receives a SCSI
Reset signal from the SCSI
interface.
Software
initialization
*Software sends the ESC @
(initialize the scanner)
command.
*The scanner receives a SCSI
Bus Device Message.