APC SILCON 10-40KW 400V UPS - Manual (Page 77)

Options/Accessories
990-4050
Installation Guide APC Silcon 10-40kW 400V UPS 77
6.6.3 Remote Display Use
The remote display is an inactive unit unable to influence the operation of the UPS: Some of
the alarms visible on the internal display are also available on the remote display (See the
Alarm section in the APC Silcon User Guide).
6.6.3.1Initiating the Remote Display
After having connected the supply the display will show:
Remote Display: “APC Silcon UPS”
6.6.3.2Communication Fault
Communication fault between UPS and remote display will appear in the display as follows:
“Data transmission interrupted”
6.6.3.3 Remote Display Setting
Use # Stack to select language and type of UPS connected to remote display.
6.6.3.4Operation
See the Operation section in the APC Silcon User Guide.
6.6.3.5Display of Measured Value
See Display of Measured Value in the APC Silcon User Guide.
Time reading not visible from the remote display.
6.6.3.6Alarms
See Alarms section in the APC Silcon User Guide.
Parameter Setting Comments
Language GB,D,F,DK, S, SF,NL, PL, CZ,
E, P, SK, H, I Language
Host SDC charger, DP300E, 300E Type of UPS connected to remote
display