AMX Modero CV7 User Manual
Page 96
Upgrading Modero Firmware
84
7" Modero Touch Panels
9.
Place a checkmark within the Automatically Ping the Master Controller to ensure availability radio
box to make sure the Master is initially responding online before establishing full communication.
10.
Click OK to close the current New TCP/IP Settings dialog and return to the previous TCP/IP
Settings dialog where you must locate your new entry within the List of Addresses section.
11.
Click the Select button to make that the currently used IP Address communication parameter.
12.
Click OK to return to the Communications Settings dialog and place a checkmark within the
Authentication Required radio box if your Master has been previously secured with a username/
password.
13.
Click on the Authentication Required radio box (if the Master is secured) and then press the User
Name and Password button to open the Master Controller User Name and Password dialog.
14.
Within this dialog, you must enter a previously configured username and password (with sufficient
rights) before being able to successfully connect to the Master.
15.
Click OK to save your newly entered information and return to the previous Communication
Settings dialog where you must click OK again to begin the communication process to your Master.
16.
Click Yes to interrupt the current communication from the Master and apply the new settings.
17.
Click Reboot (from the Tools > Reboot the Master Controller dialog) and wait for the System
Master to reboot. The STATUS and OUTPUT LEDs should begin to alternately blink during the
incorporation. Wait until the STATUS LED is the only LED to blink.
18.
Press Done once until the Master Reboot Status field reads *Reboot of System Complete*.
19.
Click the OnLine Tree tab in the Workspace window to view the devices on the System.
The default System value is one (1).
FIG. 80
Assigning Master Communication Settings and TCP/IP Settings
If you are currently connected to the assigned Master, a popup asks whether you
would want to temporarily stop communication to the Master and apply the new
settings.