Avaya PARTNER-18D - Manual (Page 24)

2 Installing Your System
14 Installing the Control Unit
Quick Reference Guide
Initializing the System
To initialize the system, you must insert any PC Card before powering up the
system.
Follow these steps to initialize a system:
1 If your PC Card comes with a write-protect tab, verify that the write-protect
tab on the PC Card is not in the write-protected position. If it is, use a
paperclip or another pointed object to push the write-protect tab on the end
of the PC Card upward to the nonprotected position.
2 To insert the PC Card, hold it with the label facing to the right, and slide it
gently into one of the PC Card slots on the processor module. When
inserted properly, the PC Card projects about 1-5/8” (4 cm) from the
module.
3 If you have a 5-slot carrier, make sure the carrier’s On/Off switch is at the
Off (“O”) position.
4 Press the power cord firmly into the power jack on the carrier or the
stand-alone processor module until the cord locks into place.
5 Plug the other end of the power cord into a properly grounded three-prong
wall outlet that is not controlled by a switch.
6 If you have a 5-slot carrier, move the On/Off switch to the On (“–”) position.
CAUTION:
The power cord should hang straight down from the connector for the
entire length of the module or carrier. Do not install the power cord at
an angle to the case or with a loop in it.
You must power down the system before you insert or remove a PC
Card.