Avaya PARTNER-18D - Manual (Page 23)

2 Installing Your System
Installing the Control Unit 13
Quick Reference Guide
CAUTION:
Batteries and battery cover are packaged in a separate box. If you are
replacing batteries, the old batteries must be removed with the power on or
the system’s memory will be lost.
Follow these steps to insert the batteries:
1 Locate the battery compartment at the bottom of the PARTNER ACS
processor module, below the extension jacks.
2 Push gently on the battery icon (the locking latch) and slide the battery icon
up to cover the plus icon; this unlocks the battery assembly.
3 Remove the battery assembly by gently pulling the tab at the bottom of the
battery compartment cover.
4 Insert two new AAA-size standard alkaline batteries into the metal battery
clips by pushing them straight in, placing the negative (—) end of one battery
into the bottom clip and the positive (+) end of the other battery into the top
clip.
5 With the locking latch in the unlocked position (battery icon and “minus”
icon visible), slide the battery assembly into the processor module along the
battery guides on the inside of the battery compartment. Push the battery
assembly in far enough that the edges of the assembly slip behind the
plastic housing of the processor module.
6 Pressing lightly on the battery icon on the front of the battery assembly,
slide the locking latch downward to secure the assembly in place. The
“plus” icon and the battery icon should now be visible on the front of the
battery assembly.