Samsung LT27B750NDX-ZA - Manual (Page 49)

Memorizing Channels
Antenna
Menu → Channel → Antenna
Before your product can memorize the available channels, you must select your TV's signal source, Air (using an
antenna) or Cable . Select Air or Cable . After you have selected the signal source, go on to the Auto Program function.
✎ Selecting the signal source using the Antenna function also determines the signal source the product is tuned
to. For example, if you receive your TV signal over the air, and you select Cable , you will see only snow. You must
select Air to see a picture.
Auto Program
Menu → Channel → Auto Program
The Auto Program function memorizes all channels that are available over the air or through your cable system and adds
them to the Channel list.
To start the Auto Program, follow these steps:
1. Go to the Auto Program menu.
2. Select Air or Cable or both, and then select Next . A c mark appears in the check box.
✎ If you selected Air or Cable in the Antenna menu, your choice will already be selected.
3. If you selected the Cable , the cable system screen appears. Select the Digital Cable System .
✎ If you selected the Air only, the Auto Program starts.
4. Select the correct cable signal format - STD , HRC or IRC .
✎ Most cable systems use STD (Standard).
5. Repeat for Analog Cable System .
6. Select Next . The Auto Program starts.
✎ After all the available channels are stored, the Auto Program removes scrambled channels. When done,
the Auto Program menu then reappears. This process can take up to 30 minutes.
English - 48 English - 49
Basic Features for the TV