Samsung HW-H750-ZA - Manual (Page 14)

14
CONNECTIONS
ATTACHING THE TOROIDAL FERRITE CORE TO THE
POWER CORD OF THE SUBWOOFER
You can reduce noise caused by electromagnetic radiation by fitting the ferrite core to the
power cord of your subwoofer.
1. Unlock and open the ferrite core.
2. Wind the power cable of your subwoofer
around the ferrite core twice.
(Start winding 2 to 4 inches away from
the core).
3. Close the ferrite core by pressing it until it
clicks.
● Before moving or installing the product, be sure to turn off the power and
disconnect the power cord.
● If the main unit is powered off, the wireless subwoofer will be in standby mode
and the STANDBY LED on the upper side will come on after the LINK indicator
(Blue LED) blinks for 30 seconds.
● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near
the Soundbar, interference may cause some sound interruption.
● The transmission distance of the wireless signal between the main unit and
subwoofer is about 33 ft., but may vary depending on your operating
environment. If a steel-concrete or metallic wall is between the main unit and the
wireless subwoofer, the system may not operate at all, because the wireless signal
cannot penetrate metal.
● If the main unit doesn't make a wireless connection, follow steps 1-6 to re-set the
connection between the main unit and wireless subwoofer.
● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit
away from water and moisture.
● For optimal listening performance, make sure that the area around the wireless
subwoofer location is clear of any obstructions.