Asante Technologies Voyager II - Manual (Page 83)

Note: The new firmware is burned into the Flash ROM during the upgrade, so you must
take care during the process and make sure it is not interrupted during the operation.
The system may be damaged seriously and need to be returned to the factory for repair
if the power cable is removed or becomes loose during the upgrade. Firmware
upgrading in a wireless network environment is not recommended because unstable
packet transmission may bring about loss of data.
When the firmware upgrade has been completed, you don't need to restart the camera
manually. The camera will reboot automatically after 60 seconds (Reboot OK). Then
open the IE browser and key in the IP address (The original IP address remains
undeleted).
Application Setting > Factory Default
You can use this function to reset to factory default, but all changes, including the IP address,
you have made are deleted.
Wait to reboot
83