Axis Communications Axis Video Server AXIS 240Q - Manual (Page 40)

40 AXIS 240Q - System Options
SNMP
The Simple Network Management Protocol (SNMP) allows the remote management of
network devices. Select the version of SNMP to use, depending on the level of security
required. Select the version of SNMP to use, by checking the appropriate box. The three
levels of security are:
• SNMP V1 - includes no security
• SNMP V2c - uses very simple security, e.g. community name as password
• SNMP V3 - provides encryption and secure passwords. Use with HTTPS.
If using V1 and V2c, enter the community name for read-only access to all supported
SNMP objects (except the root password and other objects that require write access).
Default value = public. You can also specify the community name for read/write access to
all supported SNMP objects (except read-only objects). Default value = pass.
If using HTTPS enter the password if it has not already been set. To set the password again,
the AXIS 240Q must be reset to the factory default settings.
Network - UPnP™
The video server includes support for UPnP™ in Windows ME and Windows XP. UPnP™ is
enabled by default.
Note:
UPnP ™ must be installed on your workstation. To do this, open the Control Panel from the Start Menu and
select Add/Remove Programs. Select Add/Remove Windows Components and open the Networking Ser-
vices section. Click Details and then select UPnP™ as the service to add.
Ports & Devices
I/O Ports - the pinout, interface support and the control and monitoring functions
provided by this connector are described in Unit Connectors, on page 44.
RS232 - The COM port RS-232 on the AXIS 240Q supports several operational modes
listed on this page. For more information, please see COM Ports RS-232 and RS-485, on
page 46.
RS485 - The COM ports on the AXIS 240Q supports several operational modes listed on
this page. For more information, please see COM Ports RS-232 and RS-485, on page 46.
Maintenance
• Restart - The unit is restarted without changing any of the settings. Use this method if
the unit is not behaving as expected.
• Restore - The unit is restarted and most current settings are reset to factory default val-
ues. The settings that will not be reset are:
• the boot protocol (DHCP or static)