Samsung SC-MX20E-QVC - Manual (Page 25)

English _15
Charging the Battery Pack
Be sure to charge the battery pack before you start using your memory camcorder.
Use IA-BP85ST battery pack only.
The battery pack may be charged a little at the time of purchase.
1. Slide the POWER switch downward
to turn off the power.
2. Insert the battery pack to the memory
camcorder. ➥page 14
3. Open the DC IN/USB/AV jack cover.
4. Connect the AC power adaptor to the
DC IN jack of your memory camcorder.
5. Connect the AC power adaptor to a
wall socket.
The CHG (charging) indicator lights
up in orange and showing that the
battery pack is charging.
The CHG (charging) indicator lights
up in green when the battery is fully
charged. ➥page 16
6. When the battery pack is fully charged, disconnect the AC power adaptor from the memory camcorder.
Even with the power switched off, the battery pack will still discharge if it is left attached to the memory camcorder.
It is recommended that you remove the battery pack from the memory camcorder.
•
•
•
•
•
•
Charging the battery pack in a low temperature circumstance may take longer time or fail to fully charge
(green indicator will not turn on).
Please make sure that there are no foreign substances in plug and socket when you connect AC power
supply to the memory camcorder.
Fully charge the battery pack before using.
When using the AC power supply, place it close to the wall outlet. Found with malfunction while in use of
memory camcorder, separate the AC power supply immediately from the wall outlet.
Do not use the AC power supply in a narrow and small place, such as between furnishings.
•
•
•
•
•
For recording indoors with available wall outlet, it is convenient to use the AC power supply instead of the battery pack.
It is recommended to charge the battery pack in a place with ambient temperature of 10°C ~ 30°C.
You can use the cradle for charging. ➥page 13
•
•
•
CAUTION
CARD
1
5
4 2
3