Maximum Summit Remote - Manual (Page 10)

9
Appendix B - Troubleshooting
If you have a problem with Summit, please try the following troubleshooting instructions to narrow
down the source of the problem, before contacting us. If you need further assistance you may contact
us at:
Maximum Inc.
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Fax (800) 989-2580
e-mail - [email protected]
Also check our web site for late breaking information - www.maximum-inc.com
Symptom Things to check
LED’s do not light. AC Adapter wiring.
AC adapter power, 24 to 28 VDC.
AC outlet power, 110 to 120VAC.
Indicator fuse.
Fuses keep blowing. AC Adapter wiring.
The m/s units for wind speed won’t work even though the jumpers are set correctly.
Make sure that there is a terminal connector installed in
the ice-free direction terminals and, that the connector
has a jumper wire connecting terminals #1 and 2.
The highs/lows shown are yesterdays or otherwise wrong.
Check the setting of the clock by re-booting the Summit
and resetting the clock if it’s wrong. If you keep losing
the setting check the battery.
The clock in a high/low master keeps losing its setting.
Check the battery of the clock. You can do this with a
battery tester or you can simply set the time. Wait a few
minutes then unplug the AC power. After a couple
more minutes reconnect the AC power. If the clock
comes up with midnight instead of the time you just set,
the battery is dead.