Campbell Scientific RF300-Series DRL VHF/UHF Radio Transceivers - Manual (Page 54)

APPENDIX H. RF300 RADIO SPECIFICATIONS
H-2
TRANSMITTER
Frequency Stability
±
1.5 PPM (-30
°
C to +60
°
C)
Bandwidth 16 MHz without Tuning, 20 MHz without tuning 380-403 & 450-470
MHz bands
Maximum System Deviation 5 kHz (25 kHz), 2.5 kHz (12.5 kHz)
Modulation FM/DC coupled
Input Bias 2.5V DC
±
1% temperature compensated to
±
100 mV. Supplied in
Tx/Rx
Input Impedance >40k
Distortion <3% at 60% of maximum system deviation, 1 kHz tone
Capability 1.8v P-P
±
2dB produces
±
5 kHz deviation with a 1 kHz tone
Flatness ±
2 dB, DC-5 kHz at 1 kHz (Programmable to
±
0.5 dB with
diagnostic DAC
RF Power Output 1-5W
±
20% adjustable (5W at 13.3 V nominal
Deviation Symmetry 5%
RF Output Impedance 50 ohms
Duty Cycle 50% (30 sec. Max transmit)
Adjacent Channel Power -70 dB
Intermodulation Attenuation -40 dB
Spurious and Harmonic FM -26 dBm max.
FM Hum and Noise 045 dB 25 kHz, -40 dB 12.5 kHz
TABLE H-2. RF300 Radio Specifications - VHF
GENERAL
Frequency Range 132-150 MHz/150 - 174 MHz
Frequency Control Synthesized
Channel Spacing 15/30 kHz
Mode of Operation Simplex of Half Duplex
Operation Voltage +13.3V DC nominal (10 -16V DC operational)
Regulated Supply Voltages +5V DC
±
5%
Transmit Enable 3-16V DC at 400
µ
A max
Receive Enable 3-16 DC
±
5% at 400
µ
A nominal (400
µ
A during receive)
Transceiver Enable 3-16V DC at less than 4000
µ
A
Power and Data Connector 14-pin in-line Socket (Dupont 76308-14)
RF Input/Output Connector SMA Jack (female)
Operating Temperature -30
°
C to +60
°
C
Storage Temperature -40
°
C to + 85
°
C
Humidity 95% maximum RH at 40
°
C, non-condensing
Maximum Dimensions 4.585” L, 3.25” W, 2.212” H
FCC Compliance Part 90, Part 15
DM3412 Customer must apply