beautypg.com

Campbell Scientific OBS-3A Turbidity and Temperature Monitoring System User Manual

Page 35

background image

OBS-3A Turbidity and Temperature Monitoring System

Go to the Connection tab and press Disconnect to disconnect from the OBS-
3A. Unplug the test cable. Install dummy plug and locking sleeve. The
instrument is then ready for deployment.

After setting the parameters, you can also press the Save Configuration To
File
button to save the configuration to be used at a later time.

You can press the Load Configuration From File button to load a
configuration that has previously been saved. The configuration can then be
edited and/or started in the OBS-3A.

Sensor Measurements


Select the check boxes next to the sensor measurements you wish to make.
For Depth, OBS (NTU), and OBS (mg/L), use the drop-down boxes next
to Statistics to select the desired statistics for the measurement.

Units of Measure


Select the units for depth (Meters or Feet).

27