Campbell Scientific CR510 Basic Datalogger - Manual (Page 127)

SECTION 10. PROCESSING INSTRUCTIONS
10-7
and 13 To END.
Following Instruction 98
(255 character limit)
Base 10 value of ASCII
character (Appendix E)
00 TO END.
Input locations altered: 0
*** 65 BULK LOAD ***
FUNCTION
Instruction 65 inputs given values in up to eight
Input Storage locations.
The Bulk Load instruction has 9 parameters.
The first eight are the values to be entered in
input storage locations. The ninth is the input
location for the first data value; subsequent data
values are placed in sequential input locations.
PARAM. DATA
NUMBER TYPE DESCRIPTION
01: FP Param. to be entered
02: FP "
03: FP "
04: FP "
05: FP "
06: FP "
07: FP "
08: FP "
09: 4 Starting input location
Input locations altered: 8
*** 66 ARCTAN ***
FUNCTION
Calculate the angle in degrees whose tangent is
X/Y. The polarity of X and Y must be known to
determine the quadrant of the angle, as shown
here. If 0 is entered for Parameter 2, the
Arctangent of X is the result (limits of
ARCTAN(X) are -90
°
< ARCTAN < 90
°
).
PARAM. DATA
NUMBER TYPE DESCRIPTION
01: 4 Input location of X [X]
02: 4 Input location of Y [Y]
03: 4 Destination input
location for
ARCTAN(X/Y)
Input locations altered: 1
0
90
180
270
+x -x
+y
-y
0
+90
-90
x/y > 0
x/y < 0
FIGURE 10-1. Quadrant that the Angle Falls
in is Defined by the Sign of x and y.
*** 68 EXTENDED PARAMETERS 4 DIGIT ***
FUNCTION
This instruction is used to give other instructions
additional parameters. Each of the eight
parameters in Instruction 68 is defined by the
instruction it follows. Refer to the specific
instruction that uses extended parameters.
Input location altered: 0