Ashcroft GC51 - Industrial Rangeable Pressure Transmitter - Manual (Page 26)

26
†In the setting of a pressure, the decimal point position is fixed for each
pressure range. (Refer to section 10, Power-on Message). The maximum
pressure can be set from the value which is more than 25%F.S. of the
pressure range above the minimum pressure. The values under 25%F.S.
cannot be increased or decreased by $ # key.
‡For setting of zero point and span point in the analog output, input the
percent value over the maximum display span (between OFFSET and
FULL SCALE). Its decimal point position can be set up to one digit after
decimal point as fixed point.
‡
‡
Regardless of applied pressure, the loop check can be activated, refer to
Section 13.4. This example shows the LCD display at the span point.