Ashcroft GC51 - Industrial Rangeable Pressure Transmitter - Manual (Page 15)

15
Measurement Mode Zero Adjust Mode Setting Mode
Holding Value Reset
Power ON Message
Power ON
M key for more
than 3 seconds
M key for more
than 3 seconds
if there is no
operation for
10 minutes
▲ key for more
than 3 seconds
▼ key for more
than 3 seconds
Finish
Finish
9. MODE CHANGES
• Measurement Mode (Section 11 for further detail) will be entered upon
power-on. Setting Mode (Section 13 for further detail) is entered by
pressing and holding the MODE button for more than 3 seconds. If there
is no button operation for 10 minutes in the setting mode, it will shift
back to the Measurement Mode automatically.
• To go from the Measurement Mode to the Zero Adjustment Mode
(Section 12 for further detail) press and hold the UP $ button for more
than 3 seconds.
10. POWER-ON MESSAGE
After the power is turned on, the power-on message is displayed for 6 seconds
as shown below and then the display is shifted to the measurement mode
(section 13).
All lights
Two seconds
Pressure range
Two seconds
Product
8.8.8.8.8.8.
50.0
g[51