Videotec ULISSE NETCAM - Manual (Page 30)

EN - English - I
nstruc
tions manual
28
7.2.5 Fixing the top unit
Inside the bottom cover there is a sachet
containing desiccant that is used to prevent
moisture formation in the base and near
the connector boards. Remove the sachet
during installation.
Attach the top unit (01) to the base (02) using
the attachment screws (03), supplied with the
corresponding seals (04). Make sure the base seal is
present and in good condition (05).
Pay attention to the fixing. Tightening
torque: 4Nm.
01
02
03
04
05
Fig. 45
There is only one way to anchor the base
with the top part. Align the tabs on the
sides to make sure the parts are positioned
correctly.
Fig. 46
7.3 Configuration
Before powering the device it must be configured
correctly by setting the dip-switches inside the
configuration hatch. Open the hatch by undoing the
screws as shown in the figure.
Fig. 47
7.3.1 Configuration of the dip-switches
Once the configuration cover is opened the dip-
switches will appear as shown in the figure.
Fig. 48
7.3.2 DIP1 configuration
When the dip-switch rocker is up it
represents the value 1 (ON). When the
dip-switch rocker is down it represents the
value 0 (OFF).
Dip-switch 1 is used to update the firmware.
Fig. 49
DIP1 CONFIGURATION
Description SW
4 SW
3 SW
2 SW
1 Configuration
Firmware
updating – – – ON Set up enabled
– – – OFF Set up disabled
Tab. 8