Videotec ULISSE NETCAM - Manual (Page 18)

EN - English - I
nstruc
tions manual
16
7.1.3 Connection of the camera and
motorised lens
7.1.3.1 Motorised lens PTZ board
The following is a description of the electronics board
inside the housing, which controls all functions of the
motorised lens.
MOTORISED LENS PTZ bOARD
Terminal Description
CN1 Not used.
CN2 Motorised lens motor control
connector
CN3 Motorised lens potentiometer
connector
CN6 Not used.
CN7 Camera power supply, additional
lines
Tab. 1
CN7
CN2
CN1
CN6
CN3
Fig. 11
7.1.3.2 Connector for camera/motorised
lenses
All connections illustrated below should
be made only and exclusively by expert
installers who should comply with all the
wiring and power supply specifications for
the devices.
The electronics board is designed to control cameras
with motorised lenses (Focus, Iris, Zoom), which
may or may not have potentiometers to control the
position reached.
Before making the connections make sure that the
voltages supplied by the board fall within the limits
allowed for the apparatus.
CONNECTOR FOR CAMERA/MOTORISED LENSES
Camera power supply +12V, 800mA max
Lens potentiometer power
supply +5V, 15mA max
Lens motor power supply 6-15V (adjustable), 200mA
max (Focus+ Zoom+Iris)
Tab. 2
To power the camera perform the connections as
shown in the figure.
F1
F2
A
B
+12V
GND
+12V GND
Fig. 12 CN7.