Assembly instructions for, Bc a c – Holtkoetter C8410-G5770 User Manual

Page 2

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

LICHTSTAR Triple & Quad Canopy

No. C-8310 & No. C-8410

MOUNTING INSTRUCTIONS

Please note: if a dimmer is required, it is recommended that a Lutron ELV (Electronic Low
Voltage) dimmer be used. It is recommended that this fixture be installed and hung by a
licensed electrician.

1. Disconnect the power to the outlet box before servicing.
2. Unscrew the nut (A) holding the

finished backplate (B) to the
mounting hardware / crossbar
strap (C), allowing access to the
crossbar strap (C).

3. Connect the wires from the

fixture to the wires in the outlet
box according to generally
accepted electrical standards.

4. Screw the crossbar strap (C) to

the outlet box. For item C-8410
Quad Diamond, locate the curved cut-outs in the backplate and install screws at each
location to anchor the backplate to the ceiling.

5. To secure the finished backplate (B) to the crossbar strap (C), attach the reflector or glass of

your choice using the quick-connect feature. (See the diagram and instructions on reverse)

6. The nut (A), removed in Step 2 can be discarded.

C-8310

BULB INSTALLATION

CAUTION: DISCONNECT POWER BEFORE
SERVICING.

1. Install the bulb into the socket. Be sure to use

the plastic wrap provided with the new bulb to
ensure long bulb life. Push the bulb firmly into
the socket.

2. The recommended replacement bulbs for

this fixture are 50 Watt Halostar IRC bulbs by
Osram, Holtkötter Item No. 9250*050-HSTAR.
Use of other brands of unknown quality may
cause a risk of overheating.

GLASS INSTALLATION

3. Slide the glass over the socket. Using the plastic

nut driver provided, insert the nut driver on the
inside of the glass and tighten the nut until the
glass is snug against the fixture.

4. Make sure the glass is secure, but not over-

tightened.

For Holtkötter Reflectors R-5900, R-5910, R-5920,
R-9731, R-9732 and R-9740 or Holtkötter Glass
G-5631and G-5770, please refer to the instructions
provided with the reflector or glass kit.

C-8410

Curved Cut-Outs