G5770, Assembly instructions for – Holtkoetter C8120-G5770 User Manual

Page 3

205 Hardman Avenue South, South Saint Paul, MN 55075

Voice: (800) 899-5444 • Fax: (888) 552-8661

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

LICHTSTAR Pendant “Note”

No. G-5770

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.

REMOVE GLASS FOR CLEANING
DIAGRAM 3

The “Note” glass can be removed for cleaning as
follows:

1. Lift the glass (L) up the cable.
2. Unscrew the finished reflector (M) from the

connector (N).

3. Remove the holding clip (P) by pulling it upward.
4. Remove the glass.

CAUTION: Each glass (L) and finished reflector (M)
are paired together during assembly to match the
height of the glass to the height of each reflector
and must be paired back together after cleaning
for best results.

Additionally, to prevent the glass from getting dirty
during installation, please use soft, cotton gloves to
install the glass.

5. To reinstall the glass, thread the connector (N)

through the hole in the top of the glass.

6. Put the glass holding clip (P) back into place on

the top of the connector (N).

7. Screw the finished reflector (M) back onto the

connector (N), tightening it hand-tight.

8. Slide the glass (L) down over the finished reflector

(M).

DIAGRAM 3