Holtkoetter 6319 - Manual

Holtkötter ® & Holtkötter Leuchten ® are registered trademarks
of Holtkötter International, Inc. All Rights Reserved.
© Holtkötter International, Inc.
HOLTKÖTTER INTERNATIONAL, INC.
155 Hardman Avenue South, South St. Paul, MN 55075
fax: (888) 552-8661 • phone: (800) 899-5444
www.holtkoetter.com
e-mail: [email protected]
ASSEMBLY INSTRUCTIONS FOR
Halogen Pharmacy Lamp
6319/1
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH.
Final assembly by Holtkötter International, Inc. in South St. Paul, MN.
Please make sure that the following parts for your lamp are enclosed:
A. Reflector
B. Aluminum Ring (attached to lamp)
C. Glass Shield
D. Allen Wrench (packed inside bulb box)
E. Large Washer (2 each, already installed)
F. Handle with plastic protector
G. Small Plastic Washer (attached to reflector)
H. Small Plastic Nut (attached to reflector)
I. Bayonet Base Halogen Bulb
J. Table Lamp
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth may be used to
spot clean.
Do not use common household cleaners or brass cleaners on lamps or fixtures, as the
lacquer on the outside of the brass may be damaged as a result.
Enjoy your new Holtkötter lamp.
Bulb & Reflector Installation
Step 2. Loosen the set screw with
the allen wrench (D). Then
unscrew the aluminum ring (B) from
the lamp arm. Remove one of the
large washers (E).
(D) (E)
(B)
set screw
Step 1. The brass arms are
made of soft, high-quality brass
that is pliable and may be bent
from shipping. If necessary, apply
pressure to straighten.
Step 3. Slide the reflector (A) over
the socket. Place the large washer (E)
that was removed back onto the
socket. Screw the aluminum ring (B)
back onto the socket until it is tight.
Tighten the set screw on the aluminum
ring into place. DO NOT OVERTIGHTEN.
MAKE SURE THE REFLECTOR IS STILL
LOOSE ENOUGH TO TURN.
(A)
(E)
Step 4. Put the 100-Watt halogen
bulb (I) into the socket. Hold the bulb
at the porcelain grip, push it down
slightly and turn it clockwise. BE
CAREFUL NOT TO TOUCH THE BULB
ENVELOPE WITH YOUR BARE HANDS.
Note of Caution: The recommended replacement
bulbs for this fixture are 100 W Osram Bayonet Base
Halogen bulbs. Use of other brands of unknown
quality may cause a risk of overheating.
(I)
Step 5. Align the glass shield (C) with
the small screw extending from the
bottom of the socket. Place the small
washer (G) and the small plastic nut
(H) over the screw and finger tighten.
(C)
(G)
(H)
Step 6. Next, screw on the handle (F)
and finger tighten. DO NOT
OVERTIGHTEN – THE GLASS SHIELD MAY
CRACK UNDER TOO MUCH PRESSURE.
Step 7. Plug the lamp cord into the
wall outlet. Your lamp is now
operational.
(F)