Holtkoetter 9618LED - Manual (Page 2)

e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
6
7
PLEASE NOTE: PROPER GROUNDING MUST BE ESTABLISHED FOR THIS
FIXTURE FOR IT TO WORK PROPERLY.
Remove the anti-static material only after the fixture has been
grounded. Failure to do so may result in destruction of the fixture.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
BE SURE TO TURN OFF THE CIRCUIT BREAKER BEFORE INSTALLING
THIS FIXTURE. DRY LOCATION ONLY.
Please make sure that the following parts for your low-voltage LED pendant are enclosed:
1. Fixture including ceiling canopy.
2. Additional backplate and universal crossbar strap (attached to fixture).
Mounting Instructions
1. Disconnect power to the box before installation.
2. To remove the fixture (1) from the universal crossbar strap, unscrew the finished nuts (2)
shown in Photo A and in Photo B.
3. Lift the fixture carefully off of the round backplate (3). See Photo C.
4. This will reveal two small nuts (4) holding the universal crossbar strap to the round
backplate (3). See Photo D.
5. Remove the two small nuts (4). DO NOT REMOVE THE FLAT-HEAD SCREWS.
6. Remove the universal crossbar strap (5), shown in Photo E, from the round backplate
(3).
7. Install the crossbar strap to the outlet box. Connect the wires from the fixture with the
wires in the outlet box according to generally accepted electrical standards.
8. Install the round backplate by screwing the two small nuts (4) back onto the fixture.
9. Install the fixture using the two finished nuts removed in step 2.
10. Finally, remove the anti-static material from the rest of the fixture.
A
B
D
F
E
C
1
2
3
5
3
4
5
Shorten the Length
This low-voltage pendant cannot be lengthened in the field.
Due to the nature of this support system, fixtures requiring
longer support cables will have to be special ordered.
1. To shorten the overall support cable lengths,
begin by pulling the cable cover (6), located
above the reflector, straight up to reveal the
cable guide (7).
2. Take the weight off the fixture and pull enough
cable through the guide to correct the height.
3. Cut the excess cable off, push the cable and
cable cover back into place.
Low-voltage LED Pendant
No. 9618*LED & No. 9630*LED