Assembly instructions for, Ab c – Holtkoetter 5556 User Manual

Page 2

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Mounting Instructions (continued)

1. Disconnect power to the box before installation.

2. Remove decorative knobs (C) and the brass tubular nuts (B) that are located under

the decorative knobs (C).

3. Remove the round ceiling plate (A) located on the top of canopy.

4. Mount the round ceiling plate (A) to the outlet box.

5. Connect the wires from the
fixture with the wires in the outlet
box according to generally
accepted electrical standards.
Determine the polarity of the
cord by rubbing it with your
thumb. One side will feel smooth
(= hot/black) and the other side
will feel rough (= cold/white).

6. Slide the canopy over the
round ceiling plate (A) and
secure with brass tubular nuts (B).

7. Finally put decorative knobs
(C) on the bottom of the canopy.

Low-voltage Halogen Pendants

No. 5556 & No. 5559

Please make sure that the following parts for your low-voltage pendant
are enclosed:

1. Fixture including ceiling canopy, frame and counterweight.

2. Glass shades

3. Bulbs for 5556/6 (5559/9): 6 ea (9 ea) x 20 Watt Halostar by Osram, GY6.35 base.

Order Code: 9250*020-HSTAR

This fixture utilizes an electronic, line-voltage (120 V input) to low-voltage (12 V output)
transformer by LIGHTECH, rated at 175 Watts for the 5556/6 and rated at 200 Watts for the
5559/9, allowing for a 20 Watt maximum per bulb.

If you are planning to use a dimmer with this fixture, we recommend using a Lutron ELV
(electronic low voltage) style dimmer.

NOTE: The electronic transformer by LIGHTECH is equipped with an automatic reset switch. If
the fixture is not working or has created a short, disconnect the power to the fixture and the
transformer will reset itself.

Be sure to turn off the circuit breaker before installing this fixture.
Dry location only.

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

Mounting Instructions (Diagram 1)

Parts used:

A) Round ceiling plate with three screws

B) Three brass tubular nuts

C) Three decorative knobs

Diagram 1

This manual is related to the following products:

5559