Lichtstar system suspension kit no. s-006, Assembly instructions for – Holtkoetter C8120-G User Manual
Page 3

205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
GLASS INSTALLATION
3. Slide the glass over the socket. Using the plastic
nut driver provided, insert the nut driver on the
inside of the glass and tighten the nut until the
glass is snug against the fixture.
4. Make sure the glass is secure, but not over-
tightened.
For Holtkötter Reflectors R-5900, R-5910, R-5920,
R-9731, R-9732 and R-9740 or Holtkötter Glass
G-5631and G-5770, please refer to the instructions
provided with the reflector or glass kit.
Lichtstar System Suspension Kit
No. S-006
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.
BULB INSTALLATION
CAUTION: DISCONNECT POWER BEFORE
SERVICING.
1. Install the bulb into the socket. Be sure to use
the plastic wrap provided with the new bulb to
ensure long bulb life. Push the bulb firmly into
the socket.
2. The recommended replacement bulbs for
this fixture are 50 Watt Halostar IRC bulbs by
Osram, Holtkötter Item No. 9250*050-HSTAR.
Use of other brands of unknown quality may
cause a risk of overheating.