Assembly instructions for – Holtkoetter C8110-R User Manual

Page 2

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

LICHTSTAR Single Canopy

No. C-8110 & C-8120

MOUNTING INSTRUCTIONS

Please note: if a dimmer is required, it is recommended that a Lutron ELV (Electronic Low
Voltage) dimmer be used. It is recommended that this fixture be installed and hung by a
licensed electrician.

1. Disconnect the power to the outlet box before servicing.
2. Unscrew the nut (A) holding the finished backplate (B) to the mounting hardware / crossbar

strap (C), allowing access to the crossbar strap (C).

3. Connect the wires from the canopy with the wires in the outlet box according to generally

accepted electrical standards.

4. Screw the crossbar strap (C) to the outlet box.
5. Secure the finished backplate (B) to the ceiling or canopy by attaching the quick-connect

reflector or glass of your choice (diagram and instructions on reverse).

6. The nut (A), removed in Step 2 can be discarded.

BULB INSTALLATION: S-006 SUSPENSION KIT

CAUTION: DISCONNECT POWER BEFORE
SERVICING.

1. Install the bulb into the socket. Be sure to use

the plastic wrap provided with the new bulb to
ensure long bulb life. Push the bulb firmly into
the socket.

2. The recommended replacement bulbs for

this fixture are 50 Watt Halostar IRC bulbs by
Osram, Holtkötter Item No. 9250*050-HSTAR.
Use of other brands of unknown quality may
cause a risk of overheating.

GLASS INSTALLATION

3. Slide the glass over the socket. Using the plastic

nut driver provided, insert the nut driver on the
inside of the glass and tighten the nut until the
glass is snug against the fixture.

4. Make sure the glass is secure, but not over-

tightened.

For Holtkötter Glass G-5770, please refer to the
instructions provided with the glass kit.

C-8110

C-8120