Holtkoetter 9424 - Manual (Page 2)

e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Halogen Swing-Arm Floor Lamp
No. 9424/1 & No. 9434/1
(A) Reflector
(B) Frosted Glass Shield
(C) Bulb
(D) Dimmer knob and stem
Setscrew on small dimmer knob
Installation Instructions
1. Insert the bulb into the bayonet socket. The bulb is inserted by pushing it slightly down into
the socket and then turning it clockwise. NOTE: BE CAREFUL NOT TO TOUCH THE BULB WITH
YOUR BARE HANDS.
2. Set the glass shield (B) on the grooved counterpart of the reflector (A).
3. Screw the reflector onto the base. Holding the reflector with one hand, and the glass shield
with the other hand, place the reflector and glass shield over the bulb and onto the base.
Turn the reflector clockwise until it is completely assembled.
4. Lower the dimmer stem through the hole in the bracket on the main stem into the small
dimmer knob on the base, being careful not to scratch the stem surface. Tighten the
setscrew on the small dimmer knob (near the base) with the allen wrench provided. (See
diagram.)
5. Plug lamp into your outlet. Turn the knob (D) located next to the stem for on/off and dimming
controls. The lamp is now operational.
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result.
Enjoy your new Holtkötter lamp.
Assembly Diagram