Halogen wall sconce no. 8532 “filia-l, Assembly instructions for – Holtkoetter 8532 User Manual

Page 2

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

This wall sconce comes completely assembled. Please make sure that the following parts are
enclosed:

A. 2x 60 Watt frosted Halopin Bulb (installed on fixture)
B. 2x Glass Shield (attached to fixture)
C. Allen wrench
D. Wall Sconce

IT IS FIRMLY RECOMMENDED THAT A LICENSED ELECTRICIAN INSTALL THIS
FIXTURE. DISCONNECT POWER BEFORE SERVICING.

General Installation Instructions

1. Remove both glass shields (B) from the fixture by unscrewing the finished nuts (E) with the

allen wrench (C) provided.

2. Unscrew the socket covers (F) and set aside. This will allow the backplate/crossbar strap (G)

to be removed from the wall sconce (D).

3. Mount the backplate/crossbar strap (G) to the outlet box before making the wire connections.
4. Connect the wires from the sconce with the wires in the outlet box according to

generally accepted electrical standards.

5. Slide the wall sconce (D) onto the backplate (G).
6. To secure the sconce, screw the socket covers (F) back in place.
7. Install the glass shields (B) which were removed in Step 1.

Install or Replace Bulb

1. Disconnect power to the wall sconce.
2. Using the allen wrench (C) provided, unscrew the finished nut (E) located on the glass shield.

Remove the glass shield (B).

3. Insert each Halopin bulb (A) by pushing it gently into the socket.

NOTE: BE CAREFUL NOT TO TOUCH THE BULB WITH YOUR BARE HANDS.

4. Reinstall the glass shield (B) using the previously removed finished nut (E).

Halogen Wall Sconce

No. 8532 “Filia-L”