Halogen wall sconce no. 8503, Assembly instructions for – Holtkoetter 8503 User Manual

Page 2

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Halogen Wall Sconce

No. 8503

Please make sure that the following parts for your wall sconce are enclosed:

A. 60 Watt frosted Halopin Bulb (2 each)
B. Glass Shield (two attached to fixture)
C. Allen wrench
D. Wall Sconce

IT IS FIRMLY RECOMMENDED THAT A LICENSED ELECTRICIAN INSTALL THIS
FIXTURE. DISCONNECT POWER BEFORE SERVICING.

General Installation Instructions

1. Loosen the set screw (F) with the allen wrench (C) provided. Remove the universal crossbar

strap (G) from the back of the sconce.

2. Keeping the wires threaded through the crossbar strap, connect the wires from the sconce

with the wires in the outlet box according to generally accepted electrical standards.

3. Mount the universal crossbar strap (G) to the outlet box.

4. Put the fixture (D) onto the aluminum stem attached to the crossbar strap.

5. Making sure the fixture is level, tighten the set screw (F) with the allen wrench (C).

Install or Replace Bulb

1. Disconnect power to the wall sconce.

2. Using the allen wrench (C) provided, unscrew the finished nut (E) located on the glass shield.

Remove the glass shield (B).

3. Insert the Halopin bulbs (A) by pushing them gently down into the socket.

NOTE: BE CAREFUL NOT TO TOUCH THE BULB WITH YOUR BARE HANDS.

4. Reinstall the glass shield using the previously removed finished

nut (E).