Holtkoetter 8501 User Manual

Halogen wall sconce no. 8501, Assembly instructions for

205 Hardman Avenue South, South Saint Paul, MN 55075

Voice: (800) 899-5444 • Fax: (888) 552-8661

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Please make sure that the following parts for your
wall sconce are enclosed:

A. 75 Watt frosted Halopin Bulb
B. Glass Shield (two attached to fixture)
C. Allen wrench
D. Wall Sconce

IT IS FIRMLY RECOMMENDED THAT A
LICENSED ELECTRICIAN INSTALL THIS
FIXTURE. DISCONNECT POWER BEFORE
SERVICING.

General Installation Instructions

1. Remove the universal crossbar strap/socket assembly (H) from

the back of the sconce by loosening the set screw (F) with the
allen wrench (C) provided. This will allow the crossbar strap/
socket assembly to be separated from the finished backplate
(G) and wall sconce (D).

2. Mount the universal crossbar strap (H) to the outlet box before

making the wire connections.

3. Connect the wires from the sconce with the wires in the outlet

box according to generally accepted electrical standards.

4. Put the finished backplate (G) onto the socket, followed by the

fixture (D).

5. Making sure the fixture is level, tighten the set screw (F) with the

allen wrench (C).

Halogen Wall Sconce

No. 8501

Install or Replace Bulb

1. Disconnect power to the wall sconce.
2. Using the allen wrench (C) provided, unscrew

the finished nut (E) located on the glass shield.
Remove the glass shield (B).

3. Insert the Halopin bulb (A) by pushing

it gently down into the socket.
NOTE: BE CAREFUL NOT TO TOUCH THE BULB WITH
YOUR BARE HANDS.

4. Reinstall the glass shield using the previously

removed finished nut (E).

UL requires the following safety instructions:

Lighted lamp is HOT! WARNING: Improper use of this fixture may
increase the risk of FIRE, ELECTRICAL SHOCK, EXPOSURE TO EXCESSIVE
RADIATION or INJURY TO PERSONS.

IN ORDER TO REDUCE THESE RISKS, PLEASE FOLLOW THESE SAFETY
INSTRUCTIONS:
1. Before replacing bulb, DISCONNECT power and allow bulb to

cool.

2. DO NOT touch hot glass shield or operate lamp with a missing

glass shield.

3. Keep lamp away from materials that may burn.
4. Do not remain in light if skin feels warm or look directly at a lighted bulb.
5. Use of the Osram bulb provided with this lamp prevents exposure to excessive UV Radiation.

Use of any other bulb may cause a risk of exposure to excessive UV Radiation and may also
cause a risk of overheating or may rupture the bulb.

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.