Holtkoetter 8164 - Manual

205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Swing-Arm Wall Sconce
No. 8164
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.
IT IS FIRMLY RECOMMENDED THAT A LICENSED ELECTRICIAN
INSTALL THIS FIXTURE.
Installation
1. Remove the universal crossbar strap from the back of the sconce.
2. Connect the wires from the sconce with the wires in the outlet box according to
generally accepted electrical standards.
3. Mount the crossbar strap to the outlet box after making the wire connections.
4. Mount the fixture to the crossbar strap.
Assemble the Sconce
Install the shade:
5. Unscrew the metal ring located on the socket of the lamp.
6. Place the shade over the center stem.
7. Screw the metal ring back into place, tighten hand-tight.
8. Install the bulb of your choice (not included).
Maximum Wattage: 75 Watts, Medium Edison Base.
9. Your lamp is now operational.