beautypg.com

Assembly instructions for – Holtkoetter 6551P1 User Manual

Page 2

background image

e-mail: [email protected]

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

®

and Holtkötter Leuchten

®

are registered trademarks of Holtkötter. All Rights Reserved.

© Holtkötter

F

G

E

Halogen Table Lamp

No. 6551*P1

Please make sure the following parts are included:
1. Lamp Base (A) with Punkt1 (*P1) dimmer (D)
2. Bulb (B): 75 Watt Bayonet Base Halogen Bulb by Osram

(Order Code: 9250*075-DC/CL)

3. Glass Shade (C)

Install the Bulb and Glass Shade

1. Install the new bulb, being careful not to touch the bulb envelope with your bare

hands. Hold the bulb at the porcelain grip, push it down slightly and turn it clockwise.

2. Once the bulb is installed, place the threaded end of the glass over the bulb and

onto the socket.

3. Screw the glass shade down on the fixture until it is firmly in place.
4. Your lamp is now operational.

Note of Caution

The recommended replacement bulb for this fixture is the 75 Watt Osram Bayonet Base Halogen
bulb. Use of other brands of unknown quality may cause a risk of overheating.

Replace the Fuse

An integrated fuse to protect the dimming circuit can be found in the box housing the plug.
Please check the fuse first, in case the lamp does not come on. A four (4) Amp replacement fuse
can be found on the Holtkoetter parts website: http://www.holtkoetter.com/products/parts/
fuse-4amp.aspx
or at your local automotive or electronics parts store.

1. Unscrew the screws (G) located on each corner of the plug housing (E).
2. Open the housing to reveal the circuit

board.

3. Locate the black box inside labeled

Fuse 5 x 20 (F) and open it.

4. Remove and discard old fuse;

replace with the new fuse.

5. Close the small fuse box and the plug

housing.

6. Replace and tighten the four screws

on the outside of the plug housing.

B

C

A

D