Assembly instructions for – Holtkoetter 6450P1 User Manual

Page 2

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Your “Dimm System Punkt 1” lamp comes fully assembled. If you need to replace a glass shield
or light bulb, or fuse please read the following instructions carefully.

Please save these instructions.

Replace the Glass Shield

1. Be sure to turn the lamp off and allow it to cool before attempting glass shield and/or

bulb replacement.

2. The glass shield is held in place with an aluminum spring clip. To remove this clip, hold

each side and pull firmly from the socket. This will release the glass shield.

3. Place the new glass shield over the curve of the aluminum socket.

4. Press the aluminum clip over the shield and onto the socket, making sure that both

sides snap into place.

Replace the Bulb

1. Follow steps #1 and #2 above to remove the glass shield.

2. To remove the old bulb, hold it by the porcelain grip, push in towards the socket slightly

and turn it counter-clockwise.

3. Install the new bulb, being careful not to touch the bulb envelope with your bare

hands. Hold the bulb at the porcelain grip, push it down slightly and turn it clockwise.

4. Follow steps #3 and #4 above to replace the glass shield.

Replace the Fuse

An integrated fuse to protect the dimming circuit
can be found in the base of the lamp. Please
check the fuse first, in case the lamp does not
come on. A four (4) Amp replacement fuse
can be found on the Holtkoetter parts website:
http://www.holtkoetter.com/products/parts/
fuse-4amp.aspx or at your local automotive or
electronics parts store.

Note of Caution

The recommended replacement bulb for this fixture is the 100 Watt Osram Bayonet Base Halogen
bulb. Use of other brands of unknown quality may cause a risk of overheating.

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result.

Enjoy your new Holtkötter lamp.

Glass Shield

Aluminum Clip

Bulb

Dimm System Point 1

Halogen Pharmacy Lamp

No. 6450*P1