Assembly instructions for, Ab c – Holtkoetter 6031 User Manual

Page 2

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Galileo Table Lamps

No. 6031 & No. 6032

Please make sure that the following parts for your lamp are enclosed:

In one box you will find:
1. Lamp

2. Glass bowl

3. Halopin Bulbs for base, Frosted, 2 each

Maximum Wattage for base bulbs:

Table Lamp 6031/3: 40 Watts each

End-table Lamp 6032/3: 25 Watts each

In another box you will find:
4. Hand-Washable Fabric Shade

Note: You will also need one 3-way Edison base
bulb rated: 30W-70W-100W max.
(This bulb is not included.)

INSTALL THE BASE BULBS AND GLASS

Step 2. Use the packaging provided with the bulb
to protect the bulb envelope during installation.
Push the bulb directly into the socket. Remove all
packaging.

NOTE: BE CAREFUL NOT TO TOUCH THE BULB ENVELOPE
WITH YOUR BARE HANDS.

Step 1. Prepare the lamp by
removing the aluminum ring (A)
that will hold the shade in place.
Simply unscrew the ring and set
aside.

Step 3. Set the glass bowl in place over
the base of the lamp, aligning it with the
groove in the base.

Step 4. Set the shade over the ceramic
socket and screw the aluminum ring
back in place.

Step 5. Install the 3-Way Edison base
bulb in the lamp and use the dimmer
controls to turn the lamp on. Use the
dimmer control (B) to regulate the light
output in the base.

Use the 3-way switch (C) to regulate the
light output in the shade.

Your lamp is now operational.

INSTALL THE GLASS BOWL & FABRIC SHADE