Halogen pharmacy lamp no. 6317, Assembly instructions for – Holtkoetter 6317 User Manual
Page 2
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
F
H
G
C
I
A
E
Set Screw
B
D
E
Step 2.
Loosen the set screw with the allen wrench (D). Then
unscrew the aluminum ring (B) from the lamp arm.
Remove one of the large washers (E).
Bulb and Reflector Installation
Step 4.
Put the 100-Watt halogen bulb (I) into the
socket. Hold the bulb at the porcelain grip,
push it down slightly and turn it clockwise.
BE CAREFUL NOT TO TOUCH THE BULB ENVELOPE
WITH YOUR BARE HANDS.
Note of Caution: The recommended replacement bulbs for this fixture are 100 W
Osram Bayonet Base Halogen bulbs. Use of other brands of unknown quality may
cause a risk of overheating.
Step 5.
Align the glass shield (C) with the small screw
extending from the bottom of the socket. Place the
small washer (G) and the small plastic nut (H) over
the screw and finger tighten.
Step 6.
Next, screw on the handle (F) and finger tighten.
DO NOT OVERTIGHTEN – THE GLASS SHIELD MAY
CRACK UNDER TOO MUCH PRESSURE.
Step 7.
Plug the lamp cord into the foot dimmer and the
cord from the foot dimmer into the wall outlet. Your
lamp is now operational.
Step 3.
Slide the reflector (A) over the socket. Place the large
washer (E) that was removed back onto the socket.
Screw the aluminum ring (B) back onto the socket
until it is tight. Tighten the set screw on the aluminum
ring into place. DO NOT OVERTIGHTEN. MAKE SURE
THE REFLECTOR IS STILL LOOSE ENOUGH TO TURN.
Step 1.
The brass arms are made of soft, high-quality brass
that is pliable and may be bent from shipping. If
necessary, apply pressure to straighten.
Halogen Pharmacy Lamp
No. 6317