Anritsu 373XXA - Manual (Page 22)

RECOMMENDED TEST EQUIPMENT GENERAL INFORMATION
1-10 373XXA MM
INSTRUMENT
CRITICAL
SPECIFICATION
RECOMMENDED
MANUFACTURER/MODEL
USE*
*
Computer/Controller PC with Windows 95 or later and National In-
struments GPIB hardware and software. Any O, P
Test Software ANRITSU 2300-178 O
Floppy Disk Formatted, IBM PC format DS/HD 1.44 Mbyte A
GPIB Cable ANRITSU 2100-2, or equivalent O, P,
A
RF/Microwave Cable DC – 40 GHz, K type connectors (male
or female), Length, 3 ft.
Any P, A
BNC Cable Length, 4 ft., 2 each Any O
Printer Port Test
Fixture ANRITSU B39553 O
Thru Line For models 37317A and below
For models 37325A and above: ANRITSU 3670A50-2, 3671A50-2
ANRITSU 3670K50-2, 3671K50-2 O, P
Calibration Kit For models 37317A and below, with Opt 7A:
For models 37317A and below, with Opt 7N or
7NF:
For models 37325A and above:
For models 37325A and below, with Opt 7S:
For model 37397A ANRITSU 3651-1*
ANRITSU 3653
ANRITSU 3652-1*
ANRITSU 3650-1*
ANRITSU 3654B
O, P
Performance Verifica-
tion Software ANRITSU 2300-237 P
Connector Verification
Kit For models 37217B and below w/Opt 7A:
For models 37217B and below, with Opt 7N or
7NF:
For models 37225B and above:
For models 37247B and below, with Opt 7S:
For model 37397A
ANRITSU 3667
ANRITSU 3663
ANRITSU 3668
ANRITSU 3666
ANRITSU 3669B
P
∗
Calibration Kit sliding load (Option {-1}), required for Performance Verification only.
∗∗
USE CODES:
A Adjustment / Internal Hardware Calibration
O Operational Testing
P
Performance Verification
T Troubleshooting
Table 1-1. Recommended Test Equipment (1 of 2)