Kenwood KDC-X898 - Manual (Page 94)

94 |
KDC-X998/ KDC-BT958HD/ KDC-X898/ KDC-BT858U
20. Basic operation of remote control
20-1. Before using remote control
Preparing the remote control unit
Pull the battery sheet out from the remote control
unit in the direction of the arrow.
Changing the battery of the remote control
unit
Use a commercially available button battery (CR2025).
Insert the battery with the + side facing upward,
following the illustration inside the case.
(1) Keep on sliding.
(2) Pull out.
! CAUTION
• Keep battery out of reach of children and in
original package until ready to use. Dispose of
used batteries promptly. If swallowed contact
physician immediately.
• Do not leave the battery near fire or under
direct sunlight. A fire, explosion or excessive
heat generation may result.
• Do not set the remote control in hot places
such as on the dashboard.
• The Lithium battery is in danger of explosion
if replaced incorrectly. Replace only with the
same or equivalent type.
20-2. Basic opreation
General control
• Volume control: [VOL]
• Source selection: [SRC]
Press and hold the button to turn off the power.
• Volume reduction: [ATT]
When the button is pressed again, the volume
returns to the previous level.
• Return to previous item: [ 6]
• Selection of item: [ R]/[S]
• Determination: [ENT]
• Enter Audio Control mode: [AUD]
About power on
• The remote control cannot be used to turn the power on.
Press [SRC] on the main unit.
On Tuner source
• Band selection: [FM]/[AM]
• Station selection: [ E]/[F]
• Recall preset stations: [0] – [9] Á [ENT]
On HD Radio tuner source
• Band selection: [FM]/[AM]
• Station selection: [ E]/[F]
• Recall preset stations: [0] – [9] Á [ENT]
On CD/Audio file source
• Music selection: [ E]/[F]
• Folder selection: [FM]/[AM]
• Pause/Play: [ENT]
• Enter the Music search mode: [ R]/[S]