Kenwood KDC-X898 - Manual (Page 23)

English | 23
DSP settings (KDC-X998, KDC-BT958HD)
5-8. Channel level fine adjustments
After DTA compensation, you can finely adjust
the unsatisfactory speaker volume of respective
speaker.
1
Press [SRC] and select a source other than
Standby (“STANDBY”) using [Control] knob.
Refer to
(page 14) .
2
Press [Control] knob.
Enters the Function setting mode.
3
Select “Audio Control” > “Pro Setup” > “DTA
Settings” > “Channel Level” using [Control]
knob.
For how to use [Control] knob, refer to
<3-3. How
to select the item> (page 13) .
4
Select a speaker using [Control] knob.
Speaker Display Range
Front Left speaker “Front” “L” -8 – 0 dB
Front Right speaker “Front” “R” -8 – 0 dB
Rear Left speaker “Rear” “L” -8 – 0 dB
Rear Right speaker “Rear” “R” -8 – 0 dB
Subwoofer Left “SW” “L” -8 – 0 dB
Subwoofer Right “SW” “R” -8 – 0 dB
( Colored text : Factory setting)
5
Select a value using [Control] knob.
Exiting from the Function setting mode
Press and hold [ 1/6].
5-9. Resetting of DTA Settings
You can reset the DTA-compensated values to the
factory settings.
1
Press [SRC] and select a source other than
Standby (“STANDBY”) using [Control] knob.
Refer to
(page 14) .
2
Press [Control] knob.
Enters the Function setting mode.
3
Select “Audio Control” > “Pro Setup” > “DTA
Settings” > “Reset DTA Setting” using [Control]
knob.
For how to use [Control] knob, refer to
<3-3. How
to select the item> (page 13) .
4
Select “YES” using [Control] knob.
Exiting from the Function setting mode
Press and hold [ 1/6].