HighPoint RocketRAID 2310 - Manual (Page 62)

4. If you are using the lilo boot loader, run lilo again:
# lilo
Step 5 Configure System to Mount Volumes during Startup
The system can be instructed to automatically mount the array(s) during startup by
modifying the file “/etc/fstab”.
For example, add the following line to tell the system to mount /dev/sda1 to location /
mnt/raid after startup:
/dev/sda1 /mnt/raid ext2 defaults 0 0
4 - Updating the Driver
To update the driver, simply reinstall the driver following the steps in previous
section, “ Install RocketRAID 2310 Driver on an Existing System ”.
Note: If the driver is loaded in initrd (when system is installed onto a disk or array
attached to the RocketRAID 2310), you need to run the mkinitrd command to update
the initrd file. If you are using the lilo boot loader, run lilo again (# lilo).
5 - Uninstalling the Driver
To uninstall the RocketRAID 2310 driver
Note: The driver cannot be uninstalled while the system is booted from a disk or array
attached to the RocketRAID 2310.
To uninstall the driver, remove the lines added to /etc/modules.conf and /etc/fstab.
Linux Driver Support
5-14