HighPoint RocketRAID 2310 - Manual (Page 53)

Linux Driver Support
1 - Red Hat Enterprise 3 Overview
This section provides instructions describing how to install and utilize the
RocketRAID 2310 Adapter on a Red Hat Enterprise 3 Linux system.
2 - Installing Red Hat Enterprise 3 (AS, ES, WS) Linux on the
RocketRAID 2310 controller
To install Red Hat Enterprise Linux onto disks or RAID arrays attached to
RocketRAID 2310:
Step 1 Prepare the Driver Diskette
The driver is provided in a floppy diskette image file format.
On a DOS or Windows system, a driver diskette can be generated using rawrite.exe.
This utility is included on the Red Hat Enterprise Linux CD (under /dosutils). Run
rawrite using a command prompt window, and follow the directions it provides.
On a Linux system, use the “dd” command to generate a boot diskette. Insert a
floppy disk into the floppy drive and type the following command (amd64 driver for
example):
# dd if=rh3dd-amd64.img of=/dev/fd0
Step 2 Install Red Hat Enterprise Linux
1. Start installing Red Hat Enterprise Linux by booting from the installation CD.
2. At the “Welcome to Red Hat Linux” installation screen, a prompt labeled “boot:”
will appear at the bottom of the screen. Type in linux dd, then press Enter.
boot: linux dd
3. When prompted “Do you have a driver disk?”. Select “Yes”.
4. When prompted “Insert your driver disk and press OK to continue”, insert the
driver diskette into the system’s floppy drive, and select “OK”.
5. The system will now load the RocketRAID 2310 driver automatically.
5-5