HighPoint RocketRAID 2310 - Manual (Page 26)

RocketRAID 2310 Driver and Software Installation
3. Double click the “SCSI and RAID controllers” entry. If the RocketRAID 2310
device entry is not displayed, or there are “?” or “!” marks displayed near the
RocketRAID 2310 entry, the driver has not been installed properly. Delete the
entries and reinstall the driver.
Installing the RocketRAID 2310 driver during a fresh Windows
2000/XP/2003/x64 installation
1. After booting from the Windows 2000/XP/2003 CD-ROM, when the Windows
Setup blue screen appears, look towards the bottom of the screen. Windows will
prompt you to press the F6 key if you want to install a third party SCSI or RAID
driver. Press the F6 key at this time.
2. The setup procedure will continue, and will later instruct you to press the “S” key
to specify additional adapters. Press the “S” key as instructed.
3. Next, the setup program will prompt for the insertion of the driver diskette. Please
insert the driver diskette, and then press ENTER to continue.
4. The next window will display several driver options. Please select the
RocketRAID 2310 Controller for the corresponding operating system, and press
ENTER to continue.
1 - Installing the RAID Management Console/ Interface Overview
To install the RAID software, locate the setup.exe file located on the floppy diskette
labeled “DISK 1” (or the Disk1 folder, if the software was downloaded). Double click
this file to start the Installation Wizard.
Note: If the system chassis supports SAF-TE, make sure to select the corresponding
chassis-type/manufacturer when prompted.
There is no need to restart the system after installing the software. To start the
software, click on the “Start” button, select “Programs”, and click on the “HPT
Management Console.”
4-5