HighPoint RocketRAID 4310 - Manual (Page 37)

RocketRAID BIOS Utility
To add a disk, install the hard disk, then highlight Disk from the toolbar, select
Rescan, and press Enter.
Note: After installing the disk into the hot-swap capable drive bay, wait several
seconds to allow the disk to fully power on, before using the Rescan command.
Adding/removing Arrays
To prepare a RAID array for removal, highlight the target array using the Array
window and press Enter. Highlight Array from the toolbar, select Unplug, and press
Enter.
The interface will notify you when the disk can be removed.
To add an array, install all of the RAID hard disks, then highlight Window from the
toolbar. Select Refresh, and press Enter.
Note: After installing the hard disks into the hot-swap capable drive bays, wait
several seconds to allow the disks to fully power on, before using the Rescan
command.
37