HighPoint RocketRAID 4310 - Manual (Page 20)

RocketRAID BIOS Utility
You will be asked to enter the Supervisor password.
The default password is “hpt”.
BIOS Commands
System
User/Supervisor modes – interface modes
Change password - for Supervisor mode
Exit the utility – quit and exit the RocketRAID BIOS utility
Disk
Information – displays information about the select hard disks
Initialize – initialize the selected disks (required in order to use new hard disks for
creating RAID arrays, disk replacement, or configuring spare disks.
Toggle Spare – configure spare disks.
Unplug – remove the selected disks (hot-swap)
Turn on write cache – enable write cache for the selected disks
Turn off write cache – disable write cache for the selected disks
Rescan – prompts the RocketRAID card to scan for new hard disks.
20