Outback Power Systems FX Series Installation Manual - Manual (Page 48)

46
NOTE: This is the maximum continuous DC current that the FX will draw from the batteries when inverting.
FX2012MT 190ADC (ADC = Amps DC)
FX2524MT 95ADC
FX2532MT 90ADC
FX3048T 60ADC
VFX2812M 265ADC
VFX3524M 170ADC
VFX3232M 115ADC
VFX3648 85ADC
AC INPUT OPERATING VOLTAGE RANGE
NOTE: This is the recommended AC input voltage range to be supplied to the FX. Voltages outside of
this range may damage AC loads connected to the FXs AC output terminals.
All FX Series Inverter/Chargers 90 – 150VAC (VAC = volts AC)
MAXIMUM AC INPUT CURRENT
An AC input source connected to the FX supplies power for two separate internal AC circuits – the AC
transfer switch and the battery charging system. The AC transfer switch transfers the AC input power
to the AC loads. The FX’s battery charger will “back off ” if the total AC loads—including the charger—
exceed the AC input current limit (default setting is 28AAC). This “Input Limit” can be adjusted using
the MATE to avoid overloading a generator or trip a circuit breaker. If your generator cannot produce
28AAC or you are connecting to an AC input source that has a breaker that is rated for less than
30AAC, please refer to the FX and VFX Series Inverter/Charger Programming Manual to change this
setting.
All “Mobile” FXs 30AAC per FX (AAC = Amps AC)
All 120VAC FXs 60AAC per FX (AAC = Amps AC)
MAXIMUM CURRENT FOR BATTERY CHARGER
Due to heat restraints, the FX limits incoming AC current to recharge the battery. Please refer to the FX
and VFX Series Inverter/Charger Programming Manual to adjust this setting. The battery charger has
an effi ciency of better than 80%. Other factors, such as cable losses, might reduce this effi ciency.
RATED DC INPUT CURRENT