Outback Power Systems FX Series Installation Manual - Manual (Page 24)

22
LOW-VOLTAGE WIRING
A switch can be wired to the INVERTER
and ON/OFF terminals to manually
control the FX
XCT+/XCT- are not operational
12VDC at 0.7 amps (8.4 w) is available at
the AUX+/AUX- terminals
This six-position terminal block can be
unplugged to make wiring easier and to
simplify the removal and reinstallation of an FX.
It must be securely and completely plugged
in for proper FX functioning. Otherwise,
operational errors can occur.
INVERTER and ON/OFF
• Replacing the pre-installed jumper (connecting the ON/OFF terminals) with a switch allows manual control of
the FX.
• When a jumper is installed in either location, the inverter will be ON.
• When a switch is installed, the inverter is ON when the switch is closed and OFF when the switch is open.
Control Wiring Terminal Block,
side view
INVERTER ON/OFF
Jumper
AC HOT OUT
AC NEUTRAL OUT
CHASSIS GROUND/PE
CHASSIS GROUND/PE
AC NEUTRAL IN
AC HOT IN
BATTERY
FULL OK LOW
STATUS
INVERTER AC IN ERROR
BATTERY TEMP
MATE/HUB
INVERTER ON/OFF
INVERTER
ON/OFF
AUX+ AUX- XCT- XCT+
Control Wiring Terminal Block