APC InfraStruXure Power Supply - Manual (Page 29)

InfraStruXure Site Planning, Installation, Start-Up 21
Install InfraStruXure Rack-Mount Devices
Install the Rack Automatic Transfer Switches (ATS)
Install a Rack ATS in the top of each enclosure for overhead wiring, and in the bottom of each
enclosure for wiring under the floor.
The Rack ATS is an optional component, and not all InfraStruXure systems will include it.
Install the Rack Power Distribution Units (PDU)
Install Rack PDUs in the rear of the NetShelter VX enclosure, in the channel directly behind the rear
vertical mounting rails. For overhead wiring, make sure that the power cord is pointing toward the
roof of the enclosure. For wiring under the floor, make sure that the power cord is pointing toward the
floor.
The Rack PDUs is an optional component, and not all InfraStruXure systems will include it.
Install the InfraStruXure Manager and Hub (or Switch)
Install the InfraStruXure Manager in the enclosure closest to the PDU. The CAT5 data cables
included with your configuration are of varying lengths, based on the distance components will be
installed from the PDU.
Install the APC Environmental Monitoring Unit
Install the Environmental Monitoring Unit according to the installation instructions included with the
device. The Environmental Monitoring Unit is an optional component, and not all InfraStruXure
systems will include it.
See also
See the installation instructions in the manual included with your Rack ATS.
See also
See the installation instructions in the manual included with your Rack PDU.
See also
See the installation instructions in the manual included with your InfraStruXure
Manager.