SIGMA Fit Watch User Manual
Page 24
3.2 IMPORTANT INFORMATION
3.4 FREQUENTLY ASKED QUESTIONS AND SERVICE
46
47
w w w. s i g m a s p o r t. c o m
If there is no heart rate shown on the display, this may be for the
following reasons:
•
The belt with the pulse monitor is not worn correctly.
•
The sensors (electrodes) on the pulse monitor are dirty
or not moist
•
Interference from electrical sources.
(High voltage lines, train lines etc.)
•
Transmitter battery (CR 2032) is dead (Art. No. 00342).
Please consult your doctor before you begin training – especially
if you already have a cardiovascular complaint.
The Fit Watch uses different beeps to draw your attention.
Overview of signals
Zone Alarm
1 x BEEP in Health-Zone
2 x BEEP in Fitness-Zone
3 x BEEP in Power-Zone
4 x BEEP every 20 secs. Power Zone has been exceeded.
Recovery
1 x BEEP store pulse values during recovery
3 x BEEP recovery is complete
Other Occurences
4 x BEEP every 4 secs. no signal from the chest belt.
What happens if I remove the chest belt during training?
The watch no longer receives a signal, “0” appears on the display
– after a short time the Fit Watch reverts to sleep mode (stopwatch
does not run).
What is the effect of changing from 24 hour to 12 hour clock
display, except on the time display?
The FIT WATCH automatically converts kg (24h mode) to lb (12h
mode).
Do SIGMA heart rate monitors switch off completely?
No – In sleep mode only time and date are displayed so that the
heart rate monitor can be used as a conventional watch. In this
mode your Fit Watch uses very little current.
Can I use the chest belt on a treadmill?
Yes – signals can be received and displayed by almost all appropriate
cardio machines.
The display responds sluggishly or shows a black colouration,
what is the reason for this?
The operating temperature may have been under or over exceeded.
Your heart rate monitor is designed for operating temperatures
between 0°C and 55°C.
What should I do if the display is faint?
A faint display may be the result of a weak battery. The battery
should be replaced as soon as possible – Battery type CR2032
(Art. No. 00342)
3.3 BEEP OVERVIEW
ENGLISH