Airlink Raven GPRS - Manual (Page 88)

AT Commands
80 Cingular GPRS Raven User Guide Version 2.01
IPManager (See “IP Manager translates a dynamic IP address to a fully qualified
domain name so you can contact the Raven by name as if it had a static IP.” on
page 20.) is a service from AirLink which allows a Raven with a dynamic IP to be
contacted as if it had a static IP by using a Fully Qualified Domain Name.
*DNSUSER=d.d.d.d d.d.d.d = IP of
domain server Sets a user-provided DNS to query first when perform-
ing name resolutions in the modem.
TABLE 12. IPManager
Command Parameters Details
*DOMAIN=[name] name = domain
name (i.e. eair-
link.com)
Note: Only let-
ters, numbers,
hyphens, and
periods can be
used.
Domain (or domain zone) of which the Raven is a part.
This value is used during name resolutions if a fully
qualified name is not provided and also for DNS
updates. This value can be up to 20 characters long.
If *DOMAIN=eairlink.com, then when
ATDT@remote1 is entered, the fully qualified name
remote1.eairlink.com will be used to perform a DNS
query to resolve the name to an IP address.
*IPMANAGERn=[name] n= 1 or 2
name = domain
name
Sets a domain name or IP address to send IP change noti-
fications to. Up to two independent IP Manager servers
can be set, using either AT*IPMANAGER1 or
AT*IPMANAGER2. Updates to a server can be disabled
by setting that entry to nothing (i.e.
"AT*IPMANAGER1=").
*IPMGRKEYn=[key] n= 1 or 2
key = 128-bit
key in hexadeci-
mal [32 hex
characters]
Sets the 128-bit key to use to authenticate the IP update
notifications. If the key's value is all zeros, a default key
will be used. If all the bytes in the key are set to FF, then
no key will be used (i.e. the IP change notifications will
not be authenticated). AT*IPMGRKEY1 is used to set
the key to use with AT*IPMANAGER1, while
AT*IPMGRKEY2 is used to the key with
AT*IPMANAGER2.
TABLE 11. DNS
Command Parameters Details