Airlink Raven GPRS - Manual (Page 101)

Cingular GPRS Raven User Guide Version 2.01 93
AT Commands
S11=n n=50-255 DTMF Dialing Speed (Remote)
This specifies the duration of tones in DTMF dialing.
Vn
n=0
n=1
Command Response Mode.
Terse (numeric) command responses
Verbose command responses (Default).
Xn
n=0
n=1
Extended Call Progress Result mode.
Turn off extended result codes (Default)
Turn on result codes. This adds the text 19200 to the
CONNECT response.
Z none Reset the Raven.
Note: This command does nothing if *DATZ=1.
&F none Restore Factory Setting
&V none View active profile (the contents of the active registers).
&W none Writes all changed modem settings. If this command is
not issued, any modified values will revert back to their
previous values at modem reset.
!STATUS
C3210
none Displays the current modem status. Format of response:
Current band:
Current channel:
SID: NID: Roaming:
Temp:
Pilot [NOT] acquired
Modem has [NOT] registered
!RSSI C3210 none Received Signal Strength
+CBIP? none Base Station IP Address
+CGSN none ESN (Electronic Serial Number)
+CICB
C3211
n=0
n=2
n=3
The mode for answering data/fax calls with A (Answer)
or autoanswer via S0=1.
Answer as voice (Default)
Voice
Async data for next call, then revert to Voice
TABLE 19. Commands Usable with PassThru
Command Parameters Details