Airlink Raven GPRS - Manual (Page 80)

AT Commands
72 Cingular GPRS Raven User Guide Version 2.01
TCPS=n
n=0
n=1
TCP connection time-out (TCPT) units.
TCPT specifies minutes.
TCPT specifies seconds.
TCPT=n n = minutes
(TCPS=0) or
seconds
(TCPS=1) TCP connection time-out. Specifies a time interval upon
which if there is no in or outbound traffic through a TCP
connection, the connection will be terminated. This
value only affects the TCP connection in TCP PAD
mode.
&Cn
n=0
n=1
n=2
Set DCD mode.
Always assert DCD
Assert DCD when in a data mode (UDP, TCP, PPP, or
SLIP) (Default).
Assert DCD when the modem has network coverage.
&Dn
n=0
n=2
Set DTR mode.
Ignore DTR, same effect as HW DTR always asserted
(same as S211=1)
Use hardware DTR (same as S211=0)
&Sn
n=0
n=1
n=2
Set DSR mode.
Always assert DSR
Assert DSR when in a data mode (UDP, TCP, PPP, or
SLIP) (Default).
Assert DSR when the modem has network coverage.
Note: S211 can also be used to request that DSR is
always asserted. If S211 is set to 3 and &S is changed to
a non-zero value, S211 will be changed to 1.
TABLE 5. Local Network and Host Modes
Command Parameters Details