Nitrous Express 2 Dial Progressive Controller (15835) - Manual (Page 5)

5
4.0— Installation Basics
Items Included with the NX #15835 Controller
1 - Wiring Harness
4 - Installation & User Manual
Items needed that are NOT Supplied with Controller
1 - Nitrous Kit
2 - Safety Solenoid
3 - Activation Switches as needed, If not included with the nitrous kit.
4 - 40 Amp Relay, If not included with the nitrous kit.
4 - Static Suppression Ignition Wires
Cautions and Warnings
1 - Always follow Installation Guidelines and Safety Pre-cautions when
installing this and any other related components.
2 - Remove battery Positive when installing new components and/or wiring.
3 - Install Ground Wire first, always connect before battery positive.
4 - Connect Ground wire Direct to Battery Negative Terminal and then
to the Controller .
5 - Always use proper Circuit Protection where required (fuse, circuit breaker).
6 - Do NOT mount the NX #15835 controller in close proximity to Ignition Coils,
Solenoids, or other High voltage-current devices.
6 - Always test system operation after installation to insure proper operation.
7 - Never Weld on vehicle with controller installed!
8 - Turn OFF all electronic devices before connecting, disconnecting a battery
charger.
IMPORTANT - Must use Static Suppression Ignition Wires. Can NOT use any
type of Metal Spiral Core and/or Metal Core Ignition Wires. Controller con-
tains High Frequency Digital Circuitry and can NOT function properly with
RFI or EMI Interference!